Description

100% Brand New and high-quality SemiSpare TDS meter with temperature

function.

What is TDS?

Total Dissolved Solids (TDS)are the total weight

of all solids (minerals, salts or metals) that are dissolved in a given volume

of water, express in parts per million (ppm).

the lower the TDS in the water, the more

efficiently your body’s cells actually get hydrated by the water you drink.

The higher the TDS level in the water, the

greater the probability of harmful contaminants that can pose health risks of

hinder the absorption of water molecules on the cellular level.

The EPA’s maximum contaminant level of TDS in

secondary drinking water is 500mg/L(500PPM)

USES:

Used in water purifiers and filters, food

(vegetable, fruits) & drink quality monitoring, pools, spas, aquariums and

hydroponics .

You can check the performance of your water

filter.

Check for hardness(1 grain= 17ppm).

Get assured you always drink purest water!

Function Buttons of TDS Meter

Hold function: Saves measurements for convenient reading and

recording

Auto-function: Turns off meter after 10 minutes of non-use to

conserve batteries

Dual Range: Measures from 0-999 ppm, with a resolution of 1 ppm.

From 1,000 to 9,900 ppm, the resolution is 10 ppm

   

SPECIFICATION

Range: 0-9990 ppm

Accuracy +/- 2%

Battery: 2×LR44 cell battery (INCLUDED)

Data hold. Auto temperature compensation

Auto-function: Turns off meter after 10 minutes of non-use to conserve batteries

Shows the temperature in ⁰c and ⁰F

Item size:155mm x 28mm x 15mm

Weight: Approx 70g

Auto shut-off: 10minutes.

Come with a leather case

INSTRUCTIONS FOR USING TDS METER

1. Remove the protective cap.

2. Turn the TDS Meter on.

3. Immerse the meter into the water / Solution up to the maximum

immersion level(2″)

4. Wait until the display stabilizes, The TDS meter automatically

Compensates for temperature variations Once the readout is stabilized (30 to 45

seconds). Presss the hold buttton to save reading.

5. After usage, shake of water from your meter or wipe it with a

tissue.

 

TDS METER is calibrated at 50ppm, It is recommended that the calibration level

be as close as possible to sample to be tested.

PRECATIONS

 Do not drop the entire TDS meter in water or dip beyond the

maximum immersion level (approximately 2″ – refer to manual for further

information).

This unit can be damaged if water enters the unit.